Boot lid 4D, lock motor
Boot lid 4D, lock motor |
To remove |
1. |
Remove the
Boot lid trim, 4D
.
|
2. |
Remove the cover.
|
3. |
Turn the clip holding the locking rod to the lock motor driver.
|
4. |
Take out the locking rod.
|
5. |
Pull out the centre pin from the driver and remove the driver.
|
6. |
Undo the lock motor screw.
|
7. |
Lift out the lock motor and unplug the connector.
|
To fit |
1. |
Plug in the connector and fit the motor in place. Insert the screw.
|
2. |
Fit the driver.
|
3. |
Fit the lock rod in the driver.
|
4. |
Fit the cover.
|
5. |
Insert the motor's screw. Tighten both screws.
|
6. |
Fit the
Boot lid trim, 4D
|