SAAB WIS ONLINE

C pillar trim, 5D

C pillar trim, 5D

To remove

Warning

Take care not to damage or loosen the energy absorbers. Damaged or loose energy absorbers must not be refitted. If the occasion should arise, the entire headlining must be changed. Damaged energy absorbers may impair head protection in case of a collision.




1. Detach the rear roof covering so that clearance for the D pillar trim is obtained.

2. Detach the D pillar trim by pulling it forwards (towards the front of the car), fastened with clips.

3. Remove the parcel shelf support, 3 screws, 1 with cover.

4. Pull away the C pillar trim, starting at the top. Lift out the trim, locating pin in lower edge at rear.


5. Tip the rear seat cushion forward and unscrew the lower seat-belt anchorage.


6. Remove the strap guide from the C pillar trim.

7. Pull the belt out through the C pillar trim.


To fit

Warning

Take care not to damage or loosen the energy absorbers. Damaged or loose energy absorbers must not be refitted. If the occasion should arise, the entire headlining must be changed. Damaged energy absorbers may impair head protection in case of a collision.



Important

The belt must be fitted so that it will run properly when assembly is completed.



1. Draw the belt through the C-pillar trim.

2. Fit the lower seat-belt anchorage, making sure that the guide is in the right place so that the seat cushion's hook will assume the correct position.

Tightening torque 45 Nm (33 lbf ft)

Press the strap guide into place in the C pillar trim.

3. Raise the rear seat cushion.

4. Position the C pillar trim by means of the locating pin and press the trim into place.


5. Fit the parcel shelf support, 3 screws and 1 cover.


6. Fit the D pillar trim, secured with clips. Adjust the weatherstrip over the edge of the D pillar trim.

7. Press the rear roof covering into place.