SAAB WIS ONLINE

P1641

Read the instructions below then start the fault diagnostic procedure.

Symptom: Engine fails to start. CHECK ENGINE. Misfiring before DTC is generated.

P1641


Fuel Pump Relay. No Voltage to Fuel Pump and O2S Preheating.


Fault symptoms


Engine fails to start.

CHECK ENGINE.

Misfiring before DTC is generated.


On-Board Diagnostics

Type of diagnosis:


- Continuous. But interrupted when fault criteria fulfilled and will not restart until next driving cycle.


Enable criteria:


- Engine running. Main relay voltage exceeding 10V. O2S1 and O2S2 preheating active.


Fault criteria:


- More than 15 misfires. O2S1 and O2S2 preheating current below 10mA for more than 1.5 s.


Dependents:


- None.


System reaction to a fault:


- None.


OK report:


- Enable criteria fulfilled and fault criteria not fulfilled within 60 s.


Fault handling: (See section Fault handling III, other emission-related components and functions for more information.)


- Type III.


Diagnostic help

Fault diagnosis concerns electrical fault in connecting leads or in the relay.

Functions in the diagnostic tool related to the fault:


Activation of output for fuel pump relay.


See also description on activating under "Activate" menu for more information.

Check the wiring

Jiggle the leads and in-line connectors at various points and in different directions to detect any intermittent breaks or short circuits in the wiring. Observe the multimeter, test lamp or diagnostic tool while doing this.