SPA control module, 4D
| SPA control module, 4D |
| 1. |
Open the left-hand rear door and tip forward the 60% part of the rear seat (seat cushion and backrest).
|
|
| 2. |
Loosen the door weather seal so that the side trim by the wheel housing is free
|
|
| 3. |
Remove the upper front clip of the side trim.
|
|
| 4. |
Bend aside the side trim.
|
|
| 5. |
Remove the sound absorbing cushion.
|
|
| 6. |
Loosen but do not remove the 2 control module retaining screws.
Move the control module upwards and backwards so that the screws come out of the slots. |
|
| 7. |
Undo the 2 connectors and remove the control module.
|
|
| To fit |
| 1. |
Plug in the 2 connectors, grey to grey and black to black. Fit the screws into the slots, making sure that the washers are in front of the mounting plate. Tighten the screws.
|
|
| 2. |
Fit the sound absorbing cushion.
|
|
| 3. |
Refit the side trim and secure with the clip.
|
|
| 4. |
Press the door weather seal into place.
|
|
| 5. |
Raise the rear backrest and lower the seat cushion.
|
|
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
