Rear door handle
Rear door handle |
1. |
Open the door.
|
2. |
Remove the cover around the window frame.
|
3. |
Remove the door trim.
|
4. |
Remove the water separator using
82 93 474 Removal tool
.
|
5. |
Remove the nuts and plate from the back of the handle.
|
6. |
Remove the three screws holding the lock unit.
|
7. |
Lower the lock unit slightly so that the push rod falls out.
|
8. |
Lift out the handle.
|
Fitting |
1. |
Put the handle in place.
|
2. |
Fit the plate and tighten the handle nuts.
|
3. |
Guide the push rod into the lock unit and position it in the door.
|
4. |
Screw on the lock unit.
|
5. |
Refit the water separator, door trim and cover around the window frame.
|