Front Seat
Front Seat |
|
To remove |
1. |
Slide the seat to the forward position.
If the seat cannot be operated in a fore and aft direction, emergency operation must be used so that it can be removed. |
2. |
Undo the rear of the seat, 2 bolts.
|
3. |
Slide the seat backwards and undo the front 2 bolts.
|
4. |
Remove the plastic catches from the seat. Tilt the seat backwards, cut off the cable tie and unplug the connector under the seat.
|
5. |
Lift out the seat and if necessary release the belt from the seat.
|
To fit |
1. |
Lift the seat. Plug in the connector under the seat, hooking in the plastic catches.
Fit a new cable tie. Fit the belt to the seat if it has been removed. |
2. |
Slide the rails into the front keys.
|
3. |
Thread the front bolts. Use
74 96 268 Thread locking adhesive
. Slide the seat forward. If "emergency operation" has been employed to move the seat, fit the
bevel gear
.
|
4. |
Screw in the rear screws. Use
74 96 268 Thread locking adhesive
|
5. |
Manual seat:
Make sure the catches on the right-hand and left-hand sides have engaged.
|
6. |
Tighten the rear screws with a torque wrench.
Tightening torque: 24 Nm (18 lbf ft) |
7. |
Slide the seat to the rear.
Manual seat: Make sure the catches on the right-hand and left-hand sides have engaged. |
8. |
Tighten the front screws with a torque wrench
Tightening torque: 24 Nm (18 lbf ft) |