SAAB WIS ONLINE

Camshaft seal ring

Camshaft seal ring

To remove


1. Remove Timing belt (in situ) .

2. Remove the camshaft drive wheels.


3. Remove the seal ring of the exhaust camshaft using a suitable tool. Be careful so as not to damage the sealing surface.


To fit


1. Lubricate the seal ring using 90 167 353 Silicon paste .

Fit the camshaft seal ring using 32 025 050 Fitting tool, camshaft seal .


2. Fit the camshaft drive wheels using a new bolt. Tighten the bolt just enough that it lies against the drive wheel but so that the drive wheel can still be turned in relation to the exhaust camshaft. The exhaust camshaft should be locked with 32 025 008 Camshaft fixing tool .


3. Fit Timing belt (in situ) . Before removing 32 025 008 Camshaft fixing tool , tighten the bolt of the camshaft drive wheels once the timing belt has been adjusted. The drive wheel must not turn when the bolt is tightened.

Tightening torque: 120 Nm (89 lbf ft)