SAAB WIS ONLINE

"Activate" menu

"Activate" menu

Activate Information
Glow Request

Activation command sent to the glow plug control module.

Fuel Preheater

Processor control of the transistor that grounds the relay circuit.

AC Relay

Processor control of the transistor that grounds the relay circuit.

Fan Control Output 1

Processor control of the transistor that grounds the relay circuit.

Fan Control Output 2

Processor control of the transistor that grounds the relay circuit.

Fan Control Output 3

Processor control of the transistor that grounds the relay circuit.

Swirl Control Valve

Activation command sent to the actuator.

EGR Control Valve

Activation command sent to the actuator.

Throttle Actuator

Activation command sent to the actuator.

Charge Air Control Valve

Activation command sent to the actuator.

Idle Speed



Particle Filter Regeneration

Special application forcing the regeneration of the particle filter



Adjustments Information
Starting Torque

The engine's start torque can be adjusted. The setting influence fuel consumption at start up.

Fuel Quantity Adjustment

The engine's torque can be adjusted. The setting influence fuel consumption during driving.

EGR adjustments

The engine's EGR flow can be adjusted.

Idle Speed

The engine's idling speed can be adjusted, such as to avoid vibrations.



Programming Information
Injector Replaced

Programming must be performed if this component is changed. The injector classification is loaded into the control module to ensure correct functionality.

Fuel Pressure Sensor Replaced

Programming must be performed if this component is changed. Resets the adaptation value in the control module.

Particle Filter Replaced

Programming must be performed if this component is changed. Resets the adaptation value in the control module.

Particle Filt. Pressure Sens. Repl

Programming must be performed if this component is changed. Resets the adaptation value in the control module.

Pre Catalyst Replaced

Programming must be performed if this component is changed. Resets the adaptation value in the control module.

Spare Part Programming

Programming must be performed if the control module is changed.