Limp-home solenoid
Limp-home solenoid |
To remove |
1. |
Remove the engine cover.
|
2. |
Remove the cover on the throttle body pedal arm.
|
3. |
Undo the lower bolt (it may be difficult to reach), using a magnetic T15 bit.
|
4. |
Remove the rubber seal and unplug the connector.
|
5. |
Remove the upper screw.
|
6. |
Remove the solenoid. (Not available as a separate spare part)
|
To fit |
1. |
Fit the solenoid.
|
2. |
Screw in the upper screw.
Tightening torque 2.5 Nm (1.8 lbf ft) |
3. |
Spray the connector with Kontakt 61 (part no. 30 04 520). Plug in the connector and fit the rubber seal.
|
4. |
Tighten the lower screw (it can be difficult to reach) using a magnetic T15 bit.
Tightening torque 2.5 Nm (1.8 lbf ft) |
5. |
Fit the cover on the throttle body pedal arm.
|
6. |
Put the engine cover in place.
|