Turbo bypass control valve
|
Turbo bypass control valve
|
1.
|
Remove the cover over the engine harness connector.
|
2.
|
Unplug the upper multiconnector.
|
3.
|
Unplug the two pin connector from the control valve.
|
4.
|
Unscrew both retaining nuts and loosen the windscreen cover weatherstrip.
|
5.
|
Carefully pull out the mounting plate and unhook it from edge of the bulkhead. Lift up the unit.
|
6.
|
Unplug the lower multiconnector.
|
7.
|
Mark the vacuum hoses and detach them from the valve.
|
8.
|
Lift out the holder and drill away the pop rivets.
|
1.
|
Fasten a new valve to the holder with pop rivets and lift in the holder.
|
2.
|
Connect the vacuum hoses to the valve.
|
3.
|
Plug in the lower multiconnector.
|
4.
|
Fit the mounting plate.
|
5.
|
Fit the windscreen cover weatherstrip and tighten both the retaining nuts.
|
6.
|
Spray the two pin connector with Kontakt 61 (part no. 30 04 520) and plug it into the control valve.
|
7.
|
Plug in the upper multiconnector.
|
8.
|
Fit the cover over the engine harness connector.
|