P1135
Read the instructions below then
start the fault diagnostic procedure.
Symptom: CHECK ENGINE.
O2S Heater Circuit. Current too Low, Sensor 1.
Fault symptoms
On-Board Diagnostics
Type of diagnosis:
|
-
|
Continuous. But interrupted when fault criteria fulfilled and will not restart until next driving cycle.
|
Enable criteria:
|
-
|
Test 1: Engine running. Main relay voltage exceeding 10V. Pre-heating not active.
|
|
-
|
Test 2: Engine running. Main relay voltage exceeding 10V. Pre-heating active.
|
Fault criteria:
|
-
|
Test 1: Output voltage below 2V for more than 5 s.
|
|
-
|
Test 2: Current below 300 mA for more than 5 s.
|
Dependents:
|
-
|
P1641, P1654 and P1655.
|
System reaction to a fault:
|
-
|
Closed loop is blocked.
|
OK report:
|
-
|
Enable criteria fulfilled. Fault criteria for P0135 or P0136 not fulfilled within 60 s.
|
Fault handling:
(See section
Fault handling III, other emission-related components and functions
for more information.)
Diagnostic help
Fault diagnosis concerns an electrical fault in connecting leads or in the sensor.
Functions in the diagnostic tool related to the fault:
|
•
|
Diagnostic status for the diagnosis.
|
|
•
|
Activate output for pre-heating.
|
|
•
|
Oxygen sensor pre-heating current, unit mA.
|
See also the description of activations under
Menu "Activation"
for more information.
Checking the wiring
Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short circuits. Observe the multimeter, diagnostic tool or test lamp during the check.
