Safety and handling regulations, xenon headlamp
|
Safety and handling regulations, xenon headlamp
|
General safety regulations
|
Warning
|
The following points must be followed when working on xenon headlamps:
|
•
|
Work on the headlamp assemblies should only be carried out by authorised service workshops.
|
•
|
All work must be carried out according to the instructions provided and with all necessary care. Risk of personal injury if handled improperly.
|
•
|
The ignition must always be in LOCK position when replacing components.
|
•
|
Faulty internal leads in the headlamp assemblies must be replaced in their entirety and not repaired.
|
•
|
Power to the headlamp assembly must be cut off by unplugging the connector before starting work on it.
|
•
|
Under no circumstances may power be supplied to the headlamp assembly if its protective cover is off.
|
•
|
The xenon lamp must not be turned on without being correctly fitted in the headlamp assembly with its protective cover in place.
|
•
|
Always use protective goggles and gloves when handling the xenon lamp as it is highly pressurised.
|
•
|
The xenon lamp contains mercury and must therefore be turned in for destruction.
|
|
|
|
|