SAAB WIS ONLINE

Gear selector casing

Gear selector casing

To remove



1. Put the gear selector in position N or D.

2. Remove the screw holding the front part of the gear selector casing.

3. Remove the front part.

4. Press up the SPORT button from below.

5. Unsolder the SPORT button. Lay a guard underneath so the solder does not drip onto the centre console.


6. Dismantle the lock and pull up the release button together with the rear part of the gear selector casing. Leave the electric wires in the casing.


To fit



1. Put in place the electric wiring in the lower part of the casing and fit them to the lever. Lubricate the whole U section where the release button runs with grease part no. 82 93 243. Distribute the grease evenly on all three sides so the release button runs easily.

Important

Use only grease with the specified part number due to temperature tolerances.


2. Fit the release button and press it down together with the selector casing until the screw casing is opposite the hole in the gear selector.

3. Thread the electric wires through the hole and solder on the SPORT button. Lay a guard underneath so that solder does not drop on the centre console.

4. Press in place the SPORT button.

5. Lay the electric wires in a loop so they do not get pinched and press them into the groove behind the release button.


6. Fit the lock to the release button.

7. Fit the front part of the gear selector casing.

8. Screw together the gear selector.