SAAB WIS ONLINE

Brake fluid reservoir, LHD

Brake fluid reservoir, LHD

To remove


1. Cover the wings.

2. Unplug the connector from the level sensor in the brake fluid reservoir.


3. Remove the battery cover and the battery.

4. V6 diesel engine: Remove the turbocharger heat shield.

5. Remove the main fuse box and place it to one side.

6. Remove the cap on the brake fluid reservoir and drain the reservoir using 88 19 096 Bleeding equipment .


7. Place paper towelling or a rag under the master cylinder to collect any spilt fluid.

8. Manual gearbox: Disconnect the clutch fluid hose from the brake fluid reservoir.

9. Fit the reservoir cap and withdraw the reservoir straight upwards.


To fit


1. Manual gearbox: If changing the brake fluid reservoir, cut off the top of the reservoir's hose connection.

2. Fit the reservoir onto the master cylinder. Lubricate the connections with brake grease 49 04 108 to facilitate fitting.


3. Manual gearbox: Connect the clutch fluid hose to the brake fluid reservoir. Fit the hose clip facing upwards.

4. Remove the paper.

5. Plug in the level sensor's connector and return the main fuse box to its original position.

6. Fill up with brake fluid.

7. Check the system for leakage.

8. Wipe clean.

9. Fit the main fuse box in place.


10. V6 diesel engine: Fit the turbocharger heat shield.

11. Fit the battery and the battery cover.