SAAB WIS ONLINE

Blended-air temperature sensor, LH

Blended-air temperature sensor, LH

To remove



1. Remove the data link connector, 2 screws, and detach the leads to the floor lighting.

2. Remove the lower part of the panel from the driver's side, 3 screws.

3. Pull the sensor (A) from the air duct, which leads to the lower part of the panel, by releasing the clips and sliding it out

4. Remove the radio section (A) and the ACC control panel (B).


5. Unplug the upper connector (A) (black) from the heating and ventilation unit.


6. Withdraw the pins in question from the connector (B).

7. Pull out the sensor (C).


Note

The leads in question are taped to a wiring harness. Facilitate removal by clipping the appropriate leads in a suitable spot and wire with new leads during fitting.


To fit



1. Insert new cables (B).

2. Refit the connector in the upper bracket for the heating and ventilation unit (A).

3. Refit the sensor to the lower part of the panel (A).


4. Fit the radio section (A) and the ACC control panel (B).

5. Refit the cables for the floor lighting and fit the data link connector, 2 screws.


6. Fit the lower part of the panel on the driver's side, 3 screws.


Note

New leads must be routed when refitting. Fasten the new leads to the original wiring harness.