SAAB WIS ONLINE

Rear bumper, 5D

Rear bumper, 5D

Removing


1. Remove the bolts in the wheel housing. Pull out the bumper clips from the wheel housing edges and the rear wing.


2. Open the tailgate.

3. Remove the storage compartments and their covers on both sides.


4. Remove the insulation pads. The old ones must be discarded and replaced by new ones.

5. Remove the nuts holding the bumper. The lower bolts only have nuts if the car is equipped with a towbar.


6. Lift away the bumper rearward with the help of an assistant.


Note

For cars equipped with Saab Parking Assistance (SPA):

Unplug the connectors.


Important

Be careful to avoid damaging the paintwork.



Fitting

Note

For cars equipped with Saab Parking Assistance (SPA):

Attach the connectors.



1. Put the bumper in position.


2. Press in the bumper shell over the wheel housing edge and the rear wing. Make sure the clips are correctly positioned. Fit the bolts in the wheel housing edge.


3. Tighten the nuts holding the bumper.


4. Fit the new insulation pads.


5. Fit the storage compartments and their covers on both sides.

6. Close the tailgate and check the fit of the bumper against the tailgate.