SAAB WIS ONLINE

(210-2607 utg. 2) Calibration of swirl throttle end position

Symptom: - Car has decreased performance (engine in limp-home mode). - Diagnostic trouble code P1109, P1901 or P1975.

MODIFICATION INSTRUCTION
Bulletin Nbr: 210-2607 utg. 2
Date: ........... December 2005
Market: enligt separat lista
Calibration of swirl throttle end position

Customer Satisfaction Program 154 43

Cars in stock must be rectified before delivery.

A personal communication must be sent to the owners of cars already delivered requesting them to get in touch with the nearest Saab garage as soon as possible to have the fault rectified.

Cars affected

Saab 9-3 M06 with engine alternative Z19DTH (Vehicle Identification Number 61024471 - 61032729)

Saab 9-5 M06 with engine alternative Z19DTH (Vehicle Identification Number 63501146 - 63504134)

Note

Some cars within the VIN interval are not affected. See separate information for VINs affected.


Background

The end position of the swirl throttle (403) is not calibrated.

Symptom description

- Car has decreased performance (engine in limp-home mode).

- Diagnostic trouble code P1109, P1901 or P1975.



Parts required

-

For fitting the modification identity plate:

12 785 148 Modification identity plate

93 160 907 Cleaning agent Motip Dupli, aerosol 400 ml (sufficient for 50-100 cars)

Procedure

Checking the modification identity plate

Before proceeding, check box A3 of the modification identity plate. From and including M04 the car's Warranty and Service Book contains the "Table of Modifications". A modification identity plate must be fitted in accordance with the section "Fitting the modification identity plate" where local directives require the marking of the car. If the box is not marked, continue as follows.


1. Connect Tech2.

2. Select the following in Tech2:

9-3: Fault diagnosis - 2006 - Saab 9-3 Sport (9440) - Engine - Engine management system - Activations - Actuator, swirl throttle

9-5: Fault diagnosis - 2006 - Saab 9-5 - Engine - EDC16 (1.9 TiD) - Read Values / Activations - Activate - Swirl control valve

3. Calibrate the swirl throttle as follows:

3.1. Select Increase until the 100% value is reached.

3.2. Wait for three seconds.

3.3. Select Decrease until the 0% value is reached.

4. Clear any diagnostic trouble codes.

5. Disconnect Tech2.


Marking the modification identity plate

After carrying out the procedure, mark box A3 on the modification identity plate. From and including M04 the car's Warranty and Service Book contains the "Table of Modifications". Mark the box with the number "7" if the procedure was carried out by the importer or with the number "8" if carried out by the dealer.

Fitting the modification identity plate (not US/CA)

Note

A modification identity plate must only be fitted where local directives require the marking of the car.


Fit the modification identity plate according to WIS

9-5 M04 - General - General - Technical data - Plates and labels

or

9-3 (9440) M04 - General - General - Technical data - Plates and labels

Warranty/Time Information

See separate information.