P0107
Read the instructions below then
start the fault diagnostic procedure.
Symptom: CHECK ENGINE lamp on.
Loss of performance.
Manifold Absolute Pressure Sensor Circuit. Open / Short to Ground.
Fault symptoms
On-Board Diagnostics
Type of diagnosis:
Enable criteria:
Fault criteria:
-
|
The voltage on the input is less than 0.2 V for more than 0.48 s.
|
System reaction to a fault:
-
|
Limp Home, torque limitation.
|
-
|
EGR control and boost pressure control are deactivated.
|
-
|
The control module uses a substitute value of 101.3 kPa.
|
OK report:
-
|
Fault criteria NOT fulfilled for 0.6 s.
|
Check the wiring
A fault in the control module's female connector can generate a DTC. Check the contact for oxidation, dislodge pins and pin clamping force.
Jiggle the leads and in-line connectors at various points and in different directions to detect any intermittent breaks or short circuits in the wiring. Observe the multimeter, test lamp or diagnostic tool while doing this. Check switches, connectors and crimp connections for oxidation, dislodged pins and pin clamping force.
Diagnostic help
Fault diagnosis concerns an electrical fault in connecting leads or in the sensor.
Diagnostic tool functions related to this fault are:
For more information, see also:
-
"Read Values" menu
for a description of read values.
-
"Activate" menu
for a description of applications.