P0223
Read the instructions below then
start the fault diagnostic procedure.
Symptom: CHECK ENGINE lamp on.
Idling set to 1400 rpm.
Not possible to control engine speed.
Cruise control out of order.
Pedal Position Sensor Circuit 2. Short to B+.
Fault symptoms
•
|
Idling set to 1400 rpm.
|
•
|
Not possible to control engine speed.
|
•
|
Cruise control out of order.
|
On-Board Diagnostics
Type of diagnosis:
Enable criteria:
Fault criteria:
-
|
The voltage on the input is greater than 2.5 V for more than 0.3 s.
|
System reaction to a fault:
-
|
Limp Home, engine speed limitation.
|
-
|
Cruise control is switched off.
|
Check the wiring
A fault in the control module's female connector can generate a DTC. Check the contact for oxidation, dislodge pins and pin clamping force.
Jiggle the leads and in-line connectors at various points and in different directions to detect any intermittent breaks or short circuits in the wiring. Observe the multimeter, test lamp or diagnostic tool while doing this. Check switches, connectors and crimp connections for oxidation, dislodged pins and pin clamping force.
Diagnostic help
Diagnostic tool functions related to this fault are:
•
|
Pedal position sensor 2
|
For more information, see also:
-
"Read Values" menu
for a description of read values.
-
"Activate" menu
for a description of applications.