SAAB WIS ONLINE

U0073

Read the instructions below then start the fault diagnostic procedure.

Symptom:

U0073


ECM was Missing on Bus

On-Board Diagnostics

Type of diagnosis:


- Continuous


Enable criteria:


- Turn Ignition On.


Fault criteria:


- P-bus open or short circuit for more than 0.1 s.


OK report:


- Fault criteria not fulfilled.


Check the wiring

A fault in the control module's female connector can generate a DTC. Check the contact for oxidation, dislodge pins and pin clamping force.

Jiggle the leads and in-line connectors at various points and in different directions to detect any intermittent breaks or short circuits in the wiring. Observe the multimeter, test lamp or diagnostic tool while doing this. Check switches, connectors and crimp connections for oxidation, dislodged pins and pin clamping force.

For more information, see also:

- "Read Values" menu for a description of read values.

- "Activate" menu for a description of applications.