P0327
Read the instructions below then
start the fault diagnostic procedure.
Symptom: CHECK ENGINE.
Limited engine torque.
Knock Sensor Circuit. Low Input, Bank 1.
Fault symptoms
On-Board Diagnostics
Type of diagnosis:
-
|
Continuous. But interrupted when fault criteria fulfilled and will not restart until next driving cycle.
|
Enable criteria:
-
|
Engine running. Main relay voltage exceeding 11V. Coolant temperature exceeding 60 °C.
|
Fault criteria:
-
|
Knock voltage below 0.25V when spark produced during 25 combustions.
|
Dependents:
-
|
P0116, P0117 and P0118.
|
System reaction to a fault:
-
|
Knock signal set to 5V. In this way knock detection will take place continuously on all cylinders when under high load.
|
OK report:
-
|
Enable criteria fulfilled. Fault criteria not fulfilled within 120 s.
|
Fault handling:
(See section
Fault handling III, other emission-related components and functions
for more information.)
Diagnostic help
Fault diagnosis concerns electrical fault in connecting leads or in the ignition discharge module.
Functions in the diagnostic tool related to the fault:
•
|
Knock sensor value, unit V.
|
See also description of readings under
"Read Values" menu
for more information.
Note
|
The knock sensor function is an internal function in the ignition discharge module, there are no external sensors.
|
Checking the wiring
Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short circuits. Observe the multimeter, diagnostic tool or test lamp during the check.