P1614
Read the instructions below then
start the fault diagnostic procedure.
Symptom: Cruise control not working.
Internal Control Module. Malfunction.
Fault symptoms
•
|
Cruise control not working.
|
On-Board Diagnostics
Type of diagnosis:
-
|
Continuous. But interrupted when fault criteria fulfilled and will not restart until next driving cycle.
|
Enable criteria:
-
|
Ignition in ON position and processor 339 enabling cruise control.
|
Fault criteria:
-
|
Processor 592 disabling cruise control.
|
Dependents:
System reaction to a fault:
-
|
Throttle control goes into limp-home mode. The limp-home solenoid will be activated 5 times in succession each time the ignition is turned on until the fault has been rectified and the trouble codes cleared.
|
OK report:
-
|
Accelerator pedal has been depressed at some time and then fully released. 120 s has expired since then without fault criteria being fulfilled.
|
Fault handling:
(See “Fault diagnosis, general” for more information.)
-
|
Type III. CHECK ENGINE does not go on for this trouble code.
|
Diagnostic help
Fault diagnosis concerns internal control module fault.
See
P0605
.