B1160
Read the instructions below then start the fault diagnostic procedure.
Symptom: Dipped beam does not work. Dipped beam malfunction
| B1160 |
Dipped beam relay
Fault symptoms
Dipped beam does not work.Dipped beam malfunction
Condition
The control module output is monitored and a DTC generated if there is a:| • |
Open/short circuit to ground.
|
|
| • |
Shorting to battery positive B+.
|
|
DTCs are not generated if the voltage is below 11 V or during diagnostic communication.
Diagnostic help
The output from DICE can be activated with the diagnostic tool.DTCs are not generated if the voltage is below 11 V or during diagnostic communication with DICE.
This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
