SAAB WIS ONLINE

B1785

Read the instructions below then start the fault diagnostic procedure.

Symptom: The message “SERVICE ANTI-THEFT ALARM” is shown on SID.

B1785


Siren. Open Circuit


Fault symptoms

The message “SERVICE ANTI-THEFT ALARM” is shown on SID.

Conditions

Break in the communication with the siren.

Diagnostic help

May be due to a break/short-circuit in the wiring harness to the siren. Check fuse 6 in the fuse box in the engine bay.

Main condition

The diagnostic trouble code is generated if a fault is found during two test cycles in succession. A test cycle lasts one second, i.e. it takes two seconds from when the fault occurs until a diagnostic trouble code is generated. If the fault disappears, the trouble code is cleared from the control module memory after the ignition has been turned on 20 times.

Diagnostic trouble codes are not generated if the voltage is below 11 V or over 14 V.

Checking the wiring harness

Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short-circuits in the leads. Observe the multimeter, test lamp or diagnostics instrument during the test.