SAAB WIS ONLINE

Wiring harness, boot lid, 4D

Wiring harness, boot lid, 4D


Removal

Note

If the car is equipped with a radio other than a genuine Saab radio, check that the customer has the radio code before commencing work.



1. Disconnect the negative battery cable.

2. Remove the boot lid trim .

3. Detach the LH rear edge (A) of the luggage compartment trim and carefully fold it out.


4. Unplug the wiring harness connector (A) from the car's wiring harness.


5. Detach the rubber grommet (B) from the car and thread the harness out through the rear wing.

6. Detach the wiring harness from the boot lid hinge (C).

7. Detach the grommet from the boot lid, use 82 93 474 removal tool and prise out carefully.

8. Uncouple the connectors from their components (B).


9. Undo the wiring harness from the boot lid (C) and carefully thread it out through the hole (A).


Refitting

Important

Secure the wiring harness to prevent the risk of chafing and rattling.

Check all rubber seals to minimize the risk of leakage.


Note

Spray all the connectors with “Kontakt 61” to prevent verdigris formation. Clean all the grounding points and coat them with Vaseline.



1. Thread the wiring harness in through the hole (A) in the boot lid and press the grommet into the boot lid.

2. Route the new wiring harness the same way as the old one and secure it in the same way (C).

3. Plug the connectors (B) into their respective components.

4. Thread the wiring harness through the rear wing and fit the grommet (B).


5. Attach the wiring harness to the boot lid hinge (C).

6. Plug in the connector (A) to the car's wiring harness and fasten with a cable tie.

7. Fit the luggage compartment trim (A).


8. Fit the boot lid trim .

9. Connect the negative battery cable. Set the clock and program the radio code where applicable.