Wiring harness, rear door
|
|
Wiring harness, rear door
|
|
2.
|
Remove the
speaker, rear door.
|
Note
|
|
Mark all the connectors before unplugging them from their respective components.
|
|
|
4.
|
Detach the connector (A) for the electric window lift.
|
|
5.
|
Undo all of the wiring harness cable ties (B).
|
|
6.
|
Detach the rubber grommet (A) in the B-pillar lower edge and unplug the connector (B).
|
|
7.
|
Route the wiring harness out through the hole at the front of the door (C).
|
|
Important
|
|
Secure the wiring harness to prevent the risk of chafing and rattling.
|
|
Check all rubber seals to minimize the risk of leakage.
|
|
|
|
Note
|
|
Spray all the connectors with “Kontakt 61” to prevent verdigris formation. Clean all the grounding points and coat them with Vaseline.
|
|
1.
|
Route the wiring harness in through the hole at the front of the door and fit the rubber grommet (C).
|
|
2.
|
Plug in the connector (B) and fit the rubber grommet (A).
|
|
3.
|
Position the wiring harness in accordance with the earlier routing and secure with cable ties (B).
|
|
4.
|
Plug in the connector (A) for the electric window lift.
|
