Grinding (turning) a brake disc, removed
Grinding (turning) a brake disc, removed |
Lathe “VBG 600” and the “accessory 26” connecting plate were used in the development of this method.
1. |
Remove the brake disk. Refer to
To remove
for the front wheels and
To remove
for the rear wheels.
|
2. |
Measure the disc. Refer to
Checking for lateral runout and variation in thickness, front wheels
and
Checking for lateral runout and variation in thickness, rear wheels
.
|
3. |
Clean the mating surface.
|
4. |
Fit the connecting plate on the lathe.
|
5. |
Back off the adjusting screws.
Clean the connecting surface and fit the brake disc to the connecting plate, connect the lathe. |
6. |
Adjust the turning tools against the disc with the tool holder. Remove the locking screw and move the holder.
|
7. |
Set the automatic stop.
|
8. |
Feed out the tool holder and manually grind off the outer and inner rusty edges.
|
9. |
Set the turning depth and switch on automatic operation.
|
10. |
Check the brake disc.
|
11. |
Remove the brake disc from the lathe.
|
12. |
Remove the brake disc from the lathe and fit it to the car. Refer to
To remove
for front wheels and
To remove
for rear wheels.
|