Anti-roll bar bush
Anti-roll bar bush |
1. |
Raise the car and remove the front wheel.
|
2. |
Turn the steering swivel member so that the rubber gaiter on the steering gear is compressed.
pressed together. |
3. |
Remove the front bolt from the clamp securing the anti-roll bar to the subframe and slacken the rear bolt a few turns.
|
4. |
Press the anti-roll bar forwards and lift off the bush mounting.
|
5. |
Remove the bush.
|
To fit |
1. |
Lubricate the bush with Molycote 33 and fit it with the opening facing rearwards.
|
2. |
First, tighten the front bolt securing the anti-roll bar to the subframe and then the rear bolt.
Tightening torque 25 Nm (20 lbf ft) |
3. |
Fit the wheel. See
Wheels
.
Tightening torques aluminium rim 110 Nm (81 lbf ft) pressed steel rim 50 Nm +2x90°, max. 110 Nm (37 lbf ft +2x90°, max. 81 lbf ft) Lower the car to the floor. |