C0751
Read the instructions below then start the fault diagnostic procedure.
Symptom: Message shown on the display
| C0751 |
Fault symptom
Message shown on the displayInput conditions
Vehicle speed above 20 km/h for more than 30 secondsFault criteria
Test 1: No signal from the pressure sensor within 10 minutes after the input conditions have been fulfilled.Test 2: Low battery voltage in the pressure sensor.
Test 3: Internal fault in the pressure sensor.
Diagnostic help
In the event of a fault, the control module may require up to 10 minutes of active condition to enable it to conduct a diagnosis of the fault.This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.
Our Friends
