Roof bar 5D
Roof bar 5D |
1. |
Remove the sun visor.
|
2. |
Remove the A pillar trim, secured with clips.
|
3. |
Remove the roof console and detach the courtesy handles at front and rear.
|
4. |
Detach the B pillar trim, secured with clips. Lift the pillar trim out of the air duct and place it to one side.
|
5. |
Remove the rear roof covering.
|
6. |
Detach the D pillar trim.
|
7. |
Remove the cover between the C and D pillars.
|
8. |
Detach the C pillar trim at the top.
|
9. |
Remove the cargo net lashing eyes.
|
10. |
Remove the clip securing the rear edge of the headliner by turning it 90
°
and pulling it downward.
|
11. |
Carefully pull the roof away from the door weather seal mouldings.
|
12. |
Bend down the headlining so that the roof bar nuts become accessible.
|
13. |
Remove the 4 nuts securing the roof bar.
|
14. |
Carefully lift the roof bar away.
|
To fit |
1. |
Fit the metal cover plate to the roof, if it was removed.
|
2. |
Check the seals round the screws and on the roof bar's retaining plates to make sure they are not damaged.
|
3. |
Position the roof bar and screw it in place.
Tightening torque: 20 Nm (14.7 lbf ft) |
4. |
Push up the headlining and fit it around the door weather seal mouldings.
|
5. |
Fit the clip securing the rear edge of the roof and the cargo net lashing eyes.
|
6. |
Fit the D pillar trim.
|
7. |
Press the rear roof covering in place.
|
8. |
Press the C pillar trim into place.
|
9. |
Fit the roof covering in place between the C and D pillars.
|
10. |
Fit the b pillar trim.
|
11. |
Fit the courtesy handles and roof console.
|
12. |
Fit the A pillar trim.
|
13. |
Fit the sun visor.
|