Pressure sensor, particle trap (744)
|
|
Pressure sensor, particle trap (744)
|
|
1.
|
Remove the nut holding the pressure sensor in place.
|
|
2.
|
Raise the sensor slightly and remove the connector.
|
Important
|
|
Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to
Connectors, handling and inspection
.
|
|
|
|
|
3.
|
Detach the hose and remove the sensor.
|
|
1.
|
Attach the hose to the sensor.
|
|
2.
|
Attach the connector and put the sensor in place.
|
Important
|
|
Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to
Connectors, handling and inspection
.
|
|
|
|
|
4.
|
If a new pressure sensor has been fitted: Connect the diagnostic tool to restore adaptation values.
|
