SAAB WIS ONLINE

P1451

Read the instructions below then start the fault diagnostic procedure.

Symptom: CHECK ENGINE.

P1451


EVAP Tank Pressure Sensor.Performance Problem.


Fault symptoms


CHECK ENGINE.


On-Board Diagnostics

Type of diagnosis:


- Once per driving cycle. Interrupted when fault criteria fulfilled or OK reported. Restarts next driving cycle.


Enable criteria:

Accepted transition diagnosis of oxygen sensor 1. Purge active. Idling. Max. one change in status of brake light switch. Purge adaptation higher than -8 %. Car stationary for 8 sec. The diagnosis will start once the above conditions have been fulfilled. If the diagnosis is interrupted then the speed must exceed 0 on one occasion before it is allowed to restart.

Fault criteria:


- Tank pressure pulsating with 40 Pa changes more than 39 times in 7 sec.


Dependents:


- P0444, P0445, P0501, P0502, P0506, P0507, P1444, P1445, P1576 and P1577.


System reaction to a fault:


- Integrity diagnosis of purge system blocked.


OK report:


- Diagnoses for P1451, P1452 and P1453 performed once and fault criteria not fulfilled. Fault criteria for P0452 or P0453 not fulfilled.


Fault handling: (See section Fault handling III, other emission-related components and functions for more information.)


- Type III.


Diagnostic help

Fault diagnosis concerns an electrical fault in connecting leads or in the sensor.

Functions in the diagnostic tool related to the fault:


Diagnostic status for the diagnosis.

Tank pressure value, unit kPa. The value should be approx. 0 kPa with the filler cap removed. When the car is stationary, the value should be stable.


See also description of read value under "Read Values" menu for more information.

Check the wiring

Jiggle the leads and in-line connectors at various points and in different directions to detect any intermittent breaks or short circuits in the wiring. Observe the multimeter, test lamp or diagnostic tool while doing this.