B2462, B2483, B2484

Read the instructions below then start the fault diagnostic procedure.

Symptom: The LED on the control button unit shows a red light. The OnStar Call Center (OCC) cannot locate the car.

B2462, B2483, B2484

Fault symptoms

•	The LED on the control button unit shows a red light.

•	The OnStar Call Center (OCC) cannot locate the car.

On-Board Diagnosis

Type of diagnosis:

-	Continuous

Enabling criteria:

-	Ignition ON

-	The battery voltage must be 9.5 - 15.5 V

-	The above conditions are fulfilled for more than 1 s.

Fault criteria:

-	The control module does not detect any signal from the GPS antenna for more than 1 s.

Checking the wiring harness

Jiggle the wiring harness at several points and in different directions to detect intermittent breaks and short circuits. Check switches, connectors and crimp connections for oxidation, withdrawn pins and pin clamping force.

Diagnostic help

The present fault code is erased directly the fault ceases. The historical fault codes are erased after 50 fault free driving cycles.

Diagnostics applies to

Electrical fault in the connecting leads or in the antenna.

Fault-related functions in the diagnostic tool

Reading: GPS Info