Wiring harness, boot lid, 4D
|
Wiring harness, boot lid, 4D
|
Note
|
If the car is equipped with a radio other than a genuine Saab radio, check that the customer has the radio code before commencing work.
|
1.
|
Disconnect the negative battery cable.
|
3.
|
Detach the LH rear edge (A) of the luggage compartment trim and carefully fold it out.
|
4.
|
Unplug the wiring harness connector (A) from the car's wiring harness.
|
5.
|
Detach the rubber grommet (B) from the car and thread the harness out through the rear wing.
|
6.
|
Detach the wiring harness from the boot lid hinge (C).
|
8.
|
Uncouple the connectors from their components (B).
|
9.
|
Undo the wiring harness from the boot lid (C) and carefully thread it out through the hole (A).
|
Important
|
Secure the wiring harness to prevent the risk of chafing and rattling.
|
Check all rubber seals to minimize the risk of leakage.
|
|
Note
|
Spray all the connectors with “Kontakt 61” to prevent verdigris formation. Clean all the grounding points and coat them with Vaseline.
|
1.
|
Thread the wiring harness in through the hole (A) in the boot lid and press the grommet into the boot lid.
|
2.
|
Route the new wiring harness the same way as the old one and secure it in the same way (C).
|
3.
|
Plug the connectors (B) into their respective components.
|
4.
|
Thread the wiring harness through the rear wing and fit the grommet (B).
|
5.
|
Attach the wiring harness to the boot lid hinge (C).
|
6.
|
Plug in the connector (A) to the car's wiring harness and fasten with a cable tie.
|
7.
|
Fit the luggage compartment trim (A).
|
9.
|
Connect the negative battery cable. Set the clock and program the radio code where applicable.
|