SAAB WIS ONLINE

Brake pedal, LHD

Brake pedal, LHD

To remove


1. Move the seat all the way back.

2. Remove ESP unit with control module .

3. Unplug the engine wiring harness connector and remove the holder from the bulkhead.

4. Remove the retaining nuts from the brake servo bracket/pedal assembly.


5. Remove the lower dashboard panel.

6. Unplug the pedal switches' connectors.


7. Remove the stepping motor.

8. Fasten the steering wheel to the dashboard with adhesive tape.

9. Loosen the steering shaft UJ from the steering gear without separating the splines.

10. Remove the bolts securing the pedal bracket to the steering column assembly.


11. Unhook the return spring from the pedal.

12. Remove the clip and pull out the pin.

13. Lift out the pedal assembly.


To fit


1. Fit the pedal assembly loosely to the steering column assembly and place the foam rubber damper in position between the pedal assemblies.


2. Tighten the pedal assembly nuts in the engine bay.

3. Fit ESP unit with control module

4. Fit the engine wiring harness and its holder and connect it.

5. Tighten the bolts for the pedal assembly/assemblies to the steering column assembly.

6. Fit the steering shaft UJ.

Tightening torque 25 Nm (18 lbf ft).


7. Fit the stepping motor.

8. Fit the pedal switches.

9. Fit the pin and clip and hook on the return spring.


10. Plug in the pedal switches and adjust them.

11. Fit the lower dashboard panel.

12. Reset the clock and radio code, etc.