SAAB WIS ONLINE

Coil spring (contact roller)

Coil spring (contact roller)

Warning

Read through Safety and handling instructions before starting work.


To remove


1. Ignition switch in the OFF position.

2. Remove the Airbag, driver (333D) .

3. Remove the Steering wheel .

4. Remove the upper and lower steering column covers.


5. Remove the windscreen wiper stalk switch.

6. Cut the cable tie.

7. Unplug the contact roller connector.


8. Remove the screws securing the contact roller.

9. Lift out the coil spring.


To fit


1. Check that the contact roller is locked in the centre position.

2. Put in place the contact roller and cable harness. Fit the cable tie.


3. Plug in the connector.

4. Fit the screws securing the contact roller

5. Fit the windscreen wiper stalk switch.

6. Fit the upper and lower steering column covers.


7. Fit the Steering wheel .

8. Fit the Airbag, driver (333D) .

9. Switch on the ignition and check the airbag system and control module with the diagnostic tool as follows:

Connect the diagnostic tool to the diagnostic socket under the dashboard. Delete any trouble codes.

Switch off the ignition and switch it on again. Wait at least 10 minutes with the ignition switched on.

Check whether a diagnostic trouble code (DTC) is displayed:

If a diagnostic trouble code is shown:

Carry out fault diagnosis in accordance with the directions given for each DTC.

If no diagnostic trouble code is shown:

Fitting completed correctly. Disconnect the diagnostic tool.