Section of front frame member
|
Section of front frame member
|
This description concerns joining the frame member. For replacement of the wheel housing and the front frame member, see
Front wheel housing and complete front frame member
. The description below shows the LH side.
1.
|
Position the car in an aligning bench.
|
2.
|
Remove the front wing.
|
3.
|
Remove the bumper member.
|
4.
|
Cross-measure if necessary.
|
5.
|
Drill holes in the spot-welds on the radiator crossmember-frame member mounting.
|
6.
|
Drill holes in the spot-welds on the inner front frame member up to the location for the joint. Max. 330 mm from the front edge.
|
7.
|
Cut away the inner front frame member and knock it loose.
|
8.
|
Realign the centre member if it is deformed. Only minor deformations may be rectified.
|
9.
|
If the centre frame member is to be cut, the spot-welds in the outer wheel housing must be drilled out.
|
10.
|
The centre frame member must not be cut farther than 270 mm in from the front edge.
|
1.
|
Cut the spare part roughly to size.
|
2.
|
Put the spare part in place and adjust its position exactly with the aid of the alignment bench. Fix it with a few welding clamps.
|
3.
|
Cut the spare part exactly at the edge of the existing frame member.
|
4.
|
Remove the spare part and grind clean the surfaces on it and on the body that are to be welded.
|
5.
|
Apply welding primer to the surfaces that are to be plug welded or spot welded.
|
6.
|
Fit the spare part and fixate with a couple of welding clamps.
|
7.
|
Fit the spare part in the exact position using the aligning bench measuring system.
|
8.
|
Attach the spare part with a couple of spot-welds.
|
9.
|
All-weld the joint in the frame member and spot-weld the frame member.
|
10.
|
Spot-weld the radiator crossmember mounting bracket.
|
11.
|
Smooth off the welds.
|
12.
|
Fit the bumper member.
|
13.
|
Remove any remaining welding primer. Welding primer reduces adhesion of paint, filler and sealant.
|
14.
|
Apply primer to all bare metal surfaces.
|
15.
|
Seal joints and seams with sealant.
|
16.
|
Apply underseal to the underbody and in the wheel housing after painting. Use Terostat 9320.
|
17.
|
Apply anti-corrosion agent to the interior of the frame member after painting. Use Terotex HV 400 or Mercasol 1.
|