SAAB WIS ONLINE

Bumper shell, front

Bumper shell, front

To remove


1. Cars with engine block heater: Remove the connector, 2 screws and 2 nuts.

E85 : Remove the retaining clip and the connector from the engine heater. Remove the ground cable and cable tie.

2. Raise the car and remove the front spoiler shield.


3. Lower the car to a suitable work height.

4. Remove the bumper shell bolts at the wing liner on both sides.


5. Detach the shell from the side retainer on the left side. Release the catch with a screwdriver.

6. Press the lock lug and remove the connector from the clip on the left side. Disconnect the connector.

7. Cars with headlamp washing : Place a container under the car. Remove the quick-release coupling of the headlamp washer hose. Plug the hole of the washer fluid reservoir connection.

8. Detach the shell from the side retainer on the right side. Release the catch with a screwdriver.


9. Remove the upper clips of the bumper shell. Remove the bolts.


10. Lift away the bumper shell with the help of an assistant.


To fit


1. Lift the bumper shell in place with the help of an assistant.

2. Fit the upper clips of the bumper shell. Fit the bolts.


3. Press the shell rearward and press the shell into the retainer on the right side.


4. Fit the wing liner bolts on the right side.

5. Plug in the connector and fit it on the clip on the left side.

6. Cars with headlamp washing : Remove the plug and connect the hose's quick-release coupling to the washer fluid reservoir.


7. Press the shell rearward and press the shell into the retainer on the left side.

8. Fit the wing liner bolts on the left side.

Cars with engine block heater: Fit the connector in the holder and tighten it with 2 screws and 2 nuts. The cover must open towards the centre of the car.

E85 : Plug in the connector for the engine heater and fit the retaining clip over the connector. Fit the ground cable and cable tie.

9. Raise the car.

10. Front the front spoiler shield.


11. Lower the car to the floor.