Balance Shaft Removal
Balance Shaft Removal |
Special Tools |
EN-43650 Balancer Shaft Bearing Remover and Installer
For equivalent regional tools, refer to Special Tools (LDK, LHU) .
1. |
Remove the balance shaft bearing carrier bolts.
|
2. |
Remove the balance shaft assemblies (1). |
4. |
When the
EN-43650
remover / installer is inserted in the block turn the
EN-43650
remover / installer so that the foot becomes perpendicular to the shaft.
|
5. |
Center the foot of the
EN-43650
remover / installer on the balance shaft bushing.
|
6. |
Once the
EN-43650
remover / installer is centered on the balance shaft bushing, then insert the centering guide into the front balance shaft bore and tighten the nut with an appropriate wrench.
When the EN-43650 remover / installer is properly installed, before removing the bushing, the end of the tool should be 116 mm (4.6 in) (a) from the block face. If the EN-43650 remover / installer is less than approximately 114 mm (4.5 in) (a), recheck the tool alignment. |
7. |
Tighten the nut on the
EN-43650
remover / installer (1) until the tension releases. When the tension releases, remove the
EN-43650
remover / installer and the balance shaft bushing (2).
|