Camshaft Cover Installation (LDK, LHU)

Install NEW camshaft cover grommets and camshaft cover bolts if they are serviced with the grommets.

Assemble the camshaft cover (1) and NEW gasket. Ensure that the gasket is located in the retaining groove in the camshaft cover.

Install the cover on the cylinder head and hand start the bolts.

Refer to Fastener Caution .

Install the ignition coils (4). Tighten the ignition coil bolts (3) to 10 Nm (89 lb in) .

Tighten the camshaft cover bolts to 10 Nm (89 lb in) .

Note
The solenoid valves are marked intake and exhaust.

Install the camshaft position actuator solenoid valves (2).

Install the camshaft position setting-valve bolts (1) and tighten to 10 Nm (89 lb in) .

Install the camshaft housing cover insulator (1) and bolts. Tighten the camshaft cover's insulator bolts to 10 Nm (89 lb in) .

Install the front lift bracket (1).

10.

Install the engine lift-bracket front bolts and tighten to 25 Nm (18 lb ft) .

11.

Install the power brake booster pump NEW O-ring seal (1).

12.

Note
Ensure that the exhaust camshaft slotted insert is aligned with the power brake booster pump.

Install the power brake booster pump (2).

13.

Install the brake servo pump bolts and tighten to 22 Nm (16 lb ft) .

14.

Install the rear lift bracket (1).

15.

Install the engine lift-bracket rear bolts and tighten to 25 Nm (18 lb ft) .