Cylinder Head Installation (LDK, LHU)
|
Cylinder Head Installation (LDK, LHU)
|
Special Tools
EN-45059
Angle Meter
For equivalent regional tools, refer to
Special Tools (LDK, LHU)
.
1.
|
Note
|
Do not use any sealing material.
|
Install the cylinder head gasket (2) to the block.
|
2.
|
Install the cylinder head (1). Ensure the number 1 cylinder is at top dead center (TDC). The key on the crankshaft should be on top in the 12 o'clock position.
|
3.
|
Refer to
Fastener Caution
.
Note
|
Always use NEW cylinder head fastener.
|
Install NEW cylinder head bolts.
|
|
3.1.
|
Tighten the bolts in sequence to
30 Nm (22 lb ft)
.
|
|
3.2.
|
Tighten the bolts an additional
155 degrees
in sequence using the
EN-45059
angle meter .
|
4.
|
Install the front cylinder head bolts (1) and tighten to
35 Nm (26 lb ft)
.
|