SAAB WIS ONLINE

Engine Oil and Oil Filter Replacement

Engine Oil and Oil Filter Replacement

Removal Procedure


1. Turn the ignition OFF.

2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

3.
Note

Use a 6-point socket to remove the oil filter cap.


Remove the oil filter cap (1).


4.
Note

Do NOT replace the oil filter adapter for this condition.


Remove and discard the oil filter cartridge (1).


5. Place a suitable container below the oil pan drain plug.

6. Remove the oil pan drain plug.


7. Allow the oil to drain completely.


Installation Procedure


1. Refer to Fastener Caution .

Install the oil pan drain plug with a NEW O-ring seal and tighten to 25 Nm (18 lb ft) .


2. Install the NEW oil filter cartridge (1).


3.
Warning

Lubrication must be applied to the threads of the oil filter cap prior to installation. Failure to lubricate the oil filter cap threads can hinder later removal and cause possible oil filter cap damage.


Lubricate the oil filter cap threads with clean engine oil.


4.
Warning

Proper oil filter cap tightening is mandatory. Failure to tighten the oil filter cap to the proper specification can hinder later removal and cause possible oil filter cap damage.


Note

Use a hexagonal socket to install the oil filter cap.


Install the oil filter cap (1) and tighten to 25 Nm (18 lb ft) .


5. Lower the vehicle.

6. Remove the oil filler cap.

7. Fill the engine with the appropriate oil type and quantity. Refer to Fluid and Lubricant Recommendations and Approximate Fluid Capacities .

8. Install the oil filler cap.