SAAB WIS ONLINE

Oil Pan Installation

Oil Pan Installation


Special Tools

EN 46109 Guide Pin Set

For equivalent regional tools, refer to Special Tools .



1. Install the 8 mm (0.315 in) guides from the EN 46109 guide pin into the center oil pan rail bolt hole on each side of the engine block.


2. Place a 3 mm (0.118 in) bead (1) of RTV sealant, on the block pan rail and the crankshaft rear oil seal housing. Refer to Adhesives, Fluids, Lubricants, and Sealers for the recommended sealant.


3. Position the oil pan onto the block.


4. Remove the EN 46109 guide pin 8 mm (0.315 in) guides from the engine block.


5. Loosely install the 11 oil pan bolts at cylinder block.


6. Loosely install the 2 oil pan bolts at crankshaft rear oil seal housing.

7. Refer to Fastener Caution .

Tighten the oil pan bolts in sequence as shown:


7.1. Tighten the 8 mm (0.315 in) bolts (1-11) to 23 Nm (17 lb ft) a first pass in sequence.

7.2. Tighten the 8 mm (0.315 in) bolts (1-11) to 23 Nm (17 lb ft) a second pass in sequence.

7.3. Tighten the 6 mm screws (0.236 in) (12, 13) to 10 Nm (97 lb in) .