SAAB WIS ONLINE

Fuel Pressure Gauge Installation and Removal

Fuel Pressure Gauge Installation and Removal



Callout Component Name

Preliminary Procedure

Remove the engine sight shield. Refer to Engine Sight Shield Replacement .

1

Fuel Pressure Test Check Retainer

Warning

Always apply a few drops of clean engine oil to the male pipe ends before connecting the fuel pipe fittings in order to reduce the risk of fire and personal injury. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.


2

Fuel Pressure Test Check


Procedures

1. Install EN-34730-91 tester .

2. Remove the air from the pressure tester.

3. Start the engine.

4. The set point are 380 kPa +/- 20 kPa ( 3,8 bar +/- 0,2 bar )


Special Tools

EN-34730-91 Pressure Tester

For equivalent regional tools, refer to Special Tools .