DTC P0219
DTC P0219 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptor |
DTC P0219
Engine Overspeed Condition
Circuit/System Description |
This DTC is used to indicate that the engine speed exceeded the fuel cutoff limit in gear. This DTC may set if the transmission is placed in a low gear while driving down a steep grade or traveling at a high speed.
Conditions for Running the DTC |
• |
The DTC is valid for manual transmissions only.
|
• |
The engine is running.
|
• |
The ignition voltage is between 10-18 V.
|
Conditions for Setting the DTC |
The ECM detects the engine speed is greater than 7,000 RPM for greater than 1 second.
Action Taken When the DTC Sets |
DTC P0219 is a Type A DTC.
Conditions for Clearing the DTC |
DTC P0219 is a Type A DTC.
Circuit/System Verification |
Note | ||
This DTC is used for information only. This DTC does NOT indicate there is a condition with the crank sensor or the engine control module (ECM). |
DTC P0219 is an informational DTC.