Communication Interface Module Programming and Setup
|
Communication Interface Module Programming and Setup
|
Each of the following service procedures require programming or setup procedures to be performed on the communication interface module.
Communication Interface Module Replacement
|
Note
|
•
|
It is critical to use the service replacement Communication Interface Module (CIM) only in the vehicle for which it was ordered.
|
•
|
Failure to perform the following procedures will result in a red LED, DTC(s) being set, and limited or incomplete OnStar® services
|
•
|
An OnStar® button-press to the OnStar® call center is not required to complete the procedure.
|
•
|
It may take up to 24 hours for OnStar® service to become fully activated after performing the procedures.
|
•
|
Perform the following procedure only once. Repeat attempts of the procedure may result in a delay of the activation process.
|
•
|
To fully activate an OnStar® module, both the setup and activation request procedures must be completed on all vehicles with AND without an active OnStar® subscription to insure the unit has been setup properly for the vehicle it has been installed into and also to update the OnStar® with the correct unit information.
|
•
|
To initialize the Turn-by-Turn feature, the vehicle must first be driven 8-16 km (5-10 miles) in order to allow the system to self-calibrate the dead reckoning feature.
|
•
|
Use of a J 2534-compatible diagnostic tool interface is required when performing the SPS supported OnStar® Setup and Activation (ONSU) procedure.
|
•
|
On vehicles up-fitted with TTY capabilities, it is necessary to perform a power cycle of the OnStar® Interface Module (OTIM), and toggle the TTY mode after completing the CIM installation and setup procedures.
|
1.
|
Connect the scan tool to the vehicle.
|
2.
|
Connect the Techline Information System (TIS) terminal to the scan tool.
|
3.
|
Select the OnStar® Setup and Activation (ONSU) option using the service programming system (SPS).
|
4.
|
The default language for the new CIM is English. To change the language to French or Spanish, access the scan tool.
|
5.
|
Inform the customer that it may take up to 24 hours for the OnStar® service to become fully activated.
|