SAAB WIS ONLINE

Headlamp High Beam Control Module Programming and Setup

Headlamp High Beam Control Module Programming and Setup


The following service procedures require either a programming or a setup event performed for a complete repair.

Headlamp High Beam Control Module Replacement

If the headlamp high beam control module needs to be replaced, the following procedures must be performed:


1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .

2. Perform the SPS function Headlamp High Beam Control Module - Configuration & Setup and follow the on-screen instructions. On the screen Control Module - Configuration and Setup Function(s), select both control module Configuration/Reconfiguration and the appropriate control module Setup.

3. Clear DTCs after completing the programming procedure.


Headlamp High Beam Control Module Reprogramming

This device requires no programming.