Instrument Cluster Programming and Setup
|
Instrument Cluster Programming and Setup
|
The following service procedures require either a programming or a setup event performed for a complete repair. Do not reprogram the mobile telephone control module, unless directed by a service procedure, or a service bulletin.
Instrument Cluster Replacement and/or Reprogramming
|
If the instrument cluster needs to be replaced and/or reprogrammed, the following procedures must be performed:
2.
|
Note
|
The Prepare Control Module for Removal function can only be performed when communication with the old control module is still possible.
|
Before removing the old instrument cluster, perform the SPS function Prepare Control Module for Removal.
|
3.
|
Replace the instrument cluster.
|
4.
|
Perform the SPS function Instrument Cluster - Programming and follow the on-screen instructions.
|
5.
|
Perform the SPS function Instrument Cluster - Configuration and follow the on-screen instructions.
|
6.
|
Perform the SPS function Instrument Cluster - Setup and follow the on-screen instructions.
|
7.
|
Clear DTCs after completing the programming procedure.
|