Keyless Entry Control Module Programming and Setup
|
|
Keyless Entry Control Module Programming and Setup
|
A new keyless entry control module must be programmed with the proper configurations. Ensure that the following conditions exist in order to prepare for keyless entry control module programming:
|
1.
|
This entire procedure has been reviewed before starting
|
|
2.
|
The battery is fully charged.
|
|
3.
|
The ignition switch is in the ON position.
|
|
4.
|
The MDI data link connectors are secure.
|
|
5.
|
All disconnected modules and devices are reconnected before programming.
|
|
Keyless Entry Control Module Programming
|
To program and setup a new replacement keyless entry control module, perform the following procedure:
|
1.
|
Install a scan tool with a MDI and access SPS. Refer to Service Programming System (SPS).
|
|
2.
|
Follow the screen prompts in SPS regarding programming the module.
|
|
3.
|
Check the driver information center display for additional messages regarding further calibration instructions. If there are no addition driver information center instructions present, programming is complete.
|
If the keyless entry control module fails to accept the program, perform the following steps:
|
•
|
Inspect all connections.
|
|
•
|
Verify that the scan tool has the latest software version.
|
|
Important
|
|
After programming, perform the following to avoid future misdiagnosis:
|
|
|
|
1.
|
Turn the ignition OFF, for 10 seconds.
|
|
2.
|
Install the scan tool to the data link connector.
|
|
3.
|
Turn the ignition ON with the engine OFF.
|
|
4.
|
Use the scan tool in order to retrieve history DTCs from all modules.
|
|
5.
|
Clear all history DTCs.
|
