DTC U0073 or U2100
DTC U0073 or U2100 |
Diagnostic Instructions |
• |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
• |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
• |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
DTC Descriptors |
DTC U0073 00
Control Module Communication Bus Off
DTC U0073 71
ECU HS Bus Off
DTC U0073 72
ECU LS Bus Off
DTC U2100 00
Controller Area Network (CAN) Bus Communication
DTC U2100 47
Controller Area Network (CAN) Bus Communication
Circuit/System Description |
The serial data circuits are serial data buses are used to communicate information between the control modules. The serial data circuits also connect directly to the data link connector (DLC).
Conditions for Running the DTCs |
• |
Supply voltage at the control modules is in the normal operating range.
|
• |
The vehicle power mode requires serial data communications.
|
Conditions for Setting the DTC |
The control module setting the DTC has attempted to establish communications on the serial data circuits more than 3 times in 5 seconds.
Action Taken When the DTCs Sets |
• |
The control module suspends all message transmission.
|
• |
The control module uses default values for all parameters received on the serial data circuits.
|
• |
In the TCM, DTC U0073 will cause the transmission to go into default gears.
|
• |
In the ECM and TCM, DTC U0073 will cause the malfunction indicator lamp (MIL) to illuminate.
|
• |
The control module inhibits the setting of all other communication DTCs.
|
Conditions for Clearing the DTC |
• |
The ECM/TCM modules turn OFF the MIL after 4 consecutive ignition cycles that the diagnostic runs and does not fail.
|
• |
A current DTC clears when the malfunction is no longer present.
|
• |
A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction.
|
Circuit/System Verification |
1. |
Refer to
Data Link References
to determine which serial data system is used for a specific control module.
|
2. |
This DTC cannot be retrieved with a current status. Diagnosis is accomplished using the symptom. Refer to
Symptoms - Data Communications
.
|